The EMOVE Cruiser V2 keeps all of its rider settings tucked into the LCD display, and once you know how to get in, they are simple to read and adjust. This guide is the full reference for that display: how to open the settings, what every basic P setting does, what the advanced settings control, and the factory default for each one so you can always check your Cruiser against the correct values. Keep this handy, it is the page you will come back to.
How to open the settings
Getting in
To open the settings menu on the EMOVE Cruiser V2 display, press the M button twice. From there you can scroll through the basic P settings below. The advanced settings sit behind a password, and we cover those separately.
The basic P settings
These are the everyday settings. Press the M button twice to enter, then adjust to taste. The default column is what your Cruiser V2 ships with from the factory.
| Setting | What it does | Range | Default |
|---|---|---|---|
| P1 | LCD brightness | 1 to 5 | 5 |
| P2 | Auto shutdown timer (minutes of inactivity before the display powers off) | 1 to 10 mins | 5 |
| P3 | Units, kilometers or miles | 0 for KMH, 1 for MPH | 1 |
| P4 | Gear setting (number of speed modes) | 3, 5, or 9 | 3 do not adjust |
The advanced settings
Read this before you touch the advanced menu
The advanced settings control performance-critical values like voltage, wheel size, speed limit, and current. Wrong values can make your Cruiser unsafe, can affect how it is allowed to be ridden in your area, and may affect your warranty. Several lines are marked do not adjust or not in use, and they should be left exactly as they are. If you are not completely sure what a value should be, do not change it. Contact us first and we will guide you.
To reach the advanced settings, enter A0 and use the password 6969. The table below lists what each line is and its factory default so you can check your display against it. Change only what you fully understand.
| Setting | What it is | Range / note | Default |
|---|---|---|---|
| A0 | Enter advanced settings | Password 6969 | - |
| A1 | Voltage | 48 | |
| A2 | Wheel diameter | 6 to 24 | 14.5 |
| A3 | Overall speed limit | 128 | |
| A4 | Current limiter | Always at 20 | 20 |
| A5 | Motor magnet | 15 | |
| A6 | Not in use | Do not adjust | - |
| A7 | Acceleration mode | 5 | |
| A8 | Kick start | 0 or 1 | 1 |
| A9 | Not in use | Ignore | Do not adjust |
| A10 | Not in use | Do not adjust | |
| A11 | Not in use | Do not adjust | |
| FAc | Factory reset (restores the display to default settings) | - |
Here to help
Not sure about a setting on your Cruiser V2, or your display is not matching these defaults? Send us your details and a short video of what you are seeing and we will help you set it right. It is always better to ask us than to guess in the advanced menu.
Genuine EMOVE Cruiser V2 parts
If your display or a setting points to a part, these are the genuine Cruiser V2 components.
- LCD Display for Cruiser V2View part
You can also browse the full Cruiser V2 parts collection for anything else your scooter needs.
Shop EMOVE electric scootersQuestions about a setting, or want us to walk you through the menu? Reach out to us. We ride and service the EMOVE Cruiser every day and we are here seven days a week.