Owner's guide

Teverun Fighter Supreme 7260R

How to set up, ride, charge and look after your 7260R V6. Written by VORO MOTORS in Los Angeles, from Teverun's manual, in plain English.

Get help

Covers the 7260R V6 with the 4-inch display and NFC cards. Updated November 2026.

Teverun Fighter Supreme 7260R V6 electric scooter

Your first ride

Do these once, in this order, before you ride anywhere.

  1. Get help lifting it. The 7260R weighs 141 lb. Lift it out of the crate with two people, by the frame, never by the handlebar or the fenders.
  2. Unfold it and lock the stem. See Folding and unfolding. Check the folding lever is fully closed before you go any further.
  3. Check the handlebar. It is held by 4 screws. Make sure they are tight and the bar does not twist or rock.
  4. Charge it to full. The first full charge takes about 12 hours on one charger. See Charging.
  5. Set your units. Switch the display to mph if it shows km/h. See Settings.
  6. Run the pre-ride check. Brakes, tires, throttle and bolts. See Before every ride.
  7. Start slow. Ride your first few miles in ECON or D1 in an empty car park. This scooter is far more powerful than most riders have ever used.

Protective gear

Wear a full-face helmet, plus knee, elbow and hand protection and closed shoes. Never ride in slippers, sandals or heels.

Know your scooter

The names used in this guide.

Cockpit

  • 4-inch TFT display with NFC reader
  • Thumb throttle
  • Brake levers, left and right
  • Control buttons: power, M, + and -
  • Handle grips
  • Headlight

Frame

  • Steering tube (stem) and hook
  • Folding lever
  • Steering dampers
  • Deck and rubber mat
  • Kickstand
  • Swing arms, suspension, fenders
  • Hub motors, front and rear
  • Hydraulic disc brakes, front and rear

Folding and unfolding

Teverun Fighter Supreme 7260R folded, stem lying along the deck
Folded, the 7260R measures 132 x 58 x 31 cm.

To unfold

  1. Release the stem from the hook on the deck.
  2. Raise the stem until it stands upright.
  3. Close the folding lever until it locks.
  4. Push and pull the handlebar. Nothing should move.

To fold

  1. Power the scooter off.
  2. Slide the lever's safety collar up.
  3. Open the folding lever.
  4. Press the release and lower the stem until it hooks onto the deck.

Mind your fingers

Keep fingers, hair and loose clothing clear of the folding joint and the wheels. Never ride unless the folding lever is fully closed.

The display

Unlock with the NFC cards

Your scooter comes with two cards. Hold a card flat against the display's NFC reader for a second.

  • Green "Unlock" card: unlocks the scooter so it can ride.
  • Red "Lock" card: locks it again when you park.

Keep one card on your keys and store the other at home. If you lose both, contact us. The display can also pair a blank NFC card as a spare (Settings, Make card).

Buttons

ButtonPressWhat it does
PowerHold 1 secondTurns the display on or off
+TapMoves up one gear (towards S)
-TapMoves down one gear (towards ECON)
+HoldTurns external power on or off
MTapChanges what the information bar shows
MHoldSwitches between single and dual motor
MTap twice quicklyOpens Settings

Reading the screen

  • Centre: your real-time speed, in mph or km/h.
  • Left and right numbers: rear and front motor power.
  • Bottom bar: battery charge (SOC) as a percentage and an energy bar.
  • Information bars: tap M to cycle through trip distance, total miles, front and rear motor current, motor temperature, average speed and top speed.
  • Gear strip: the gear you are in (P, R, ECON, D1, D2, D3, S).

Status icons

IconMeans
Green arrow, left or rightThat turn signal is on
HeadlightThe headlight is on
BluetoothBlinking: not connected. Steady: connected.
One wheel or two wheelsSingle or dual motor drive. Hold M to switch.
Plug with lightning boltExternal power is on. Hold + to switch.
KICK STARTKick start mode is on: push off with your foot, then use the throttle
Speedometer with AUTOCruise control is on
Red circle with !You are braking
Brake fault (top row, next to cruise)A brake problem: stop and contact us

Gears and modes

Tap + to go up and - to go down. Each gear allows more speed and power than the one before.

GearUse it for
PPark. The throttle does nothing. The scooter drops into P after standing still for a while. Squeeze a brake to leave P.
RReverse. Only select it when you are fully stopped.
ECONLow speed and the gentlest power. Start here while you learn the scooter, and on busy paths.
WalkPedestrian gear (a green walking figure on the screen), for walking the scooter alongside you.
D1 D2 D3Everyday riding, from mild to strong.
SSport. Full power, for experienced riders on open, legal roads only.

Single or dual motor

Single motor saves battery and is calmer on wet or loose ground. Dual motor gives full acceleration and hill climbing. Hold M to switch, ideally while stopped.

Settings

Tap M twice quickly to open Settings. Use + and - to move through the list, and M to choose or confirm. To leave, pick Exit or tap M twice again. If the display asks for a code you never set, contact us and we will walk you through it.

SettingWhat it does
Brightness10 levels. Press M until "Brightness" flashes, adjust with + and -, press M to confirm.
UnitMiles (mph) or kilometres (km/h).
Auto offTurns the display off after 1 to 60 minutes of no use, or Never.
PACK infoBattery details: charge level, voltage, temperature, cycle count and any battery fault code. Useful to read out to us if you need help.
Make cardPairs a blank NFC card as a spare key. Hold the blank card against the reader when asked.

Leave the service menus alone

Settings also holds Wheel diameter, System voltage, Function parameters and Gear parameters. These are factory and service settings. A wrong value makes the speedometer read wrong, can damage the controller, and is not covered by the warranty. If you think one needs changing, contact us first.

Warning lights

If a red or orange warning icon lights up, stop somewhere safe, switch off, and wait a minute before switching on again. If it comes back, do not keep riding. Take a photo of the screen and contact us.

IconFault
Box marked F or RFront or rear controller fault
Red [FM] or [RM]Front or rear motor phase loss
Yellow [FM] or [RM]Front or rear motor hall sensor fault
Triangle with lightning boltBattery fault
Throttle shapeThrottle fault
Battery with + and -System voltage too low
Screen shapeDisplay fault
ThermometerSystem over temperature. Stop and let it cool down.

Charging

  1. Open the charge port cap.
  2. Plug the charger into the scooter first, then into the wall.
  3. Watch the charger light: red means charging, green means full.
  4. When it is full, unplug from the wall, then from the scooter.
  5. Close the charge port cap before you ride.

A full charge takes about 12 hours with one charger. A small spark when you first connect is normal.

Charging rules

  • Use only the charger that came with your scooter or a genuine replacement from us.
  • Charge indoors, somewhere dry and ventilated, away from anything that burns. Never in a closed car.
  • Never leave it charging while you are out or asleep.
  • Never ride while it is plugged in.
  • The charger is not waterproof. Keep it and the port dry.
  • Do not touch the plug pins for 10 seconds after unplugging.
  • Pull by the plug, never the cable. Do not use a charger with a damaged cable or a port with corroded pins.
  • Keep children and pets away from the charger.
  • If the charger light stays off, the charger fell, or the cable is damaged, stop using it and contact us.

Battery care

32 to 113°F

Safe charging temperature (0 to 45°C)

14 to 140°F

Safe riding temperature (-10 to 60°C)

70 to 80%

Charge level for storage over 3 months

1 to 2 hours

Wait before charging after coming in from the cold

  • Cold weather: expect less range and power below freezing. That is normal and recovers when it warms up.
  • Storage: keep it indoors at room temperature, out of sun and rain. Not in a car trunk. For long storage, leave it at 70 to 80%, not full and not empty, and top it up every few months.
  • Ageing: like every lithium battery, capacity drops slowly with use, typically by more than 15% after about 300 full cycles.
  • Never open the battery, the controller or the motors. Opening them is dangerous and voids the warranty.
  • After a hard knock or a crash, stop charging and riding and have it inspected.

If the battery smokes, swells, leaks or smells sour

Stop charging and using it at once. If it is safe to do so, move it outdoors, away from buildings. Use a fire extinguisher. Do not use water. Call 911 if there is fire, then contact us.

Before every ride

Two minutes, every time.

  • Throttle: press and release it 2 to 3 times. It must spring back to zero on its own.
  • Brakes: both levers feel firm. No oil on the calipers or discs. Pads are not worn thin. Discs are not bent and their bolts are tight.
  • Tires: correct pressure, no cuts, and tread left.
  • Handlebar: no play or rocking.
  • Folding lever: fully closed and locked.
  • Bolts: swing arms, suspension, axles and the handlebar are tight.
  • Lights and battery: lights work and there is enough charge for the trip.

Riding safely

  • One adult rider only. No passengers, no children.
  • Keep both hands on the bar and a finger ready on the brakes.
  • Brake with both levers together. Do not grab the front brake hard on its own, and do not drag your feet to stop.
  • Slow down before turns, speed bumps, kerbs and crossings. Walk the scooter across crosswalks.
  • Avoid wet, icy, crowded, steep or broken surfaces. No stunts or jumps.
  • Come to a full stop before you select reverse.
  • Fold the kickstand up before you move.
  • Ride at night only with your lights on and visible clothing, and slower than in daylight.
  • After a ride, the motors and brake discs are hot. Do not touch them.
  • Follow your state and city rules on speed, where you can ride, and age.

Rain and water

The 7260R is not waterproof. Avoid riding in rain or on wet roads: grip and braking get much worse, and water can get into the electrics. If you get caught in light rain, slow right down, ride home gently and let it dry. Never ride through standing water, and never hose or pressure wash it. Water damage is not covered by the warranty.

Maintenance

  • Lift the wheels off the ground before working on the scooter, and switch it off.
  • Do not over-tighten. Damage from over-torqued screws is not covered by the warranty. The display mount uses M4 x 8 mm and M4 x 12 mm screws, and the button pod uses M3 x 8 mm.
  • Check bolts regularly. Motor, rim and axle bolts can loosen over time.
  • Brake noise: a light hum from the discs at around 10 to 20 mph is normal. A constant metal scraping usually means a bent disc or worn pads.
  • Wear parts: tires, brake pads, discs, cables, bearings, suspension and folding parts wear with use. Inspect them regularly and replace them when worn. We stock 7260R parts in the US.
  • Use the right length bolts. If you ever refit the power switch or anything near the battery, use the original length bolt. A longer one can pierce the battery.
  • Handlebar accessories: the display clamp fits 31.8, 25.4 and 22.2 mm bars. The two smaller sizes need the adapter rings.

Shop 7260R parts

When to stop and contact us

Stop riding and get in touch if you notice any of these.

  • A warning icon that comes back after a restart
  • The throttle does not spring back to zero
  • Weak, spongy or noisy brakes, or oil on a disc
  • A motor that gets unusually hot
  • Range or charging much worse than normal
  • A new knocking, grinding or rattling noise
  • Smoke, sparks (other than when plugging in), or a sour smell
  • It got soaked or rode through water

Specs

Top speed75 mph
RangeUp to 124 miles (varies with speed, rider weight, terrain and weather)
Battery72V 60Ah
Charge timeAbout 12 hours with one charger
MotorsDual 2500W, 16,800W peak combined
ControllersDual 100A sine wave
Brakes4-piston hydraulic, front and rear
Tires13-inch tubeless
Max rider weight330 lb
Scooter weight141 lb
Folded size132 x 58 x 31 cm
Display4-inch TFT with NFC unlock

Help and warranty

Every new 7260R from VORO comes with a 1-year factory warranty. Opening the battery, controller or motors, over-tightened screws, changed service settings and water damage are not covered.

If you bought your 7260R from us, parts and repairs come from us too. When you contact us, have your order number ready and, if the display shows a warning, a photo of it.